NO.

failure

reason

solution

1

There is no signal on the display

the sensor wire is not well connected or the sensor wire is broken

reconnect the sensor wire or replace the sensor wire

2

there is not any information/data on the display

There is no battery inside or the battery is out of power or the positive and the negative pole is wrong.

please replace the battery or check whether the positive and negative pole is right or not

3

there is some noise on the pedal

the pedal is loose

fasten the pedal with wrench

4

there is some noise from the saddle

the saddle is not fastened well

please fix the saddle firmly

5

the driving belt is sliding

the driving belt is too loose.

please open the plastic cover and adjust the bolt to make sure the belt is tight enough

6

the equipment is not stable

The end cap for the stabilizer is not in correct position or the floor it not flat.

First make sure put the equipment on a flat floor and then adjust the end cap until the equipment is stable.

7

there is some noise but can not make sure where is come from

Some part is loose or short of lubrication in the moving part.

Check each fastening part and fix it again. Check the moving part and make sure there is enough lubrication.

8

the resistance is too low or there is not any resistance at all or cannot adjust the resistance controller smoothly.

The resistance wire is too loose or too tight.

adjust the resistance wire in which connect the upper and lower part to keep it in suitable position

9

the angle of the handlebar is not correct

assembly wrong

please assemble the handlebar according to the manual